Some V-Core builds end at the first successful print. KI Hestad's didn't even get close to stopping there, and we've loved following along for every part of it.
KI Hestad runs a YouTube channel where 3D printing meets motorcycle fabrication, and he's exactly the kind of builder we had in mind when we designed the V-Core: a proper DIYer at heart, the sort of maker who'd rather build something himself than buy it ready made. Across a full series, he put together a V-Core 4.1, the 500×500 size, from unboxing to finished machine. Then he kept going: he used the printer to run his own engineering test on threaded inserts, got the first result wrong in public, fixed it, and finally put a 3D printed part to work on a real motorcycle. Every video is worth your time, and together they're a good look at what the V-Core is actually for once the build thread is closed.
500×500 build volume · Hybrid upgrade fitted · 7 build & test videos · 1 motorcycle on the road
Part 1 to 4: Building the V-Core 4.1
The series opens with the unboxing and runs through the full mechanical build.
Part 1: Unboxing & Brass Inserts
We loved this one: first look at the kit, a tour of the build guide, and installing the brass inserts that hold the frame together.
Part 2: The Frame Build
Squaring up and assembling the frame, then fitting the bottom plate, every bolt and T-nut sorted before it all comes together.
Part 3: CoreXY and the V-Core 4.1 Hybrid Upgrade
One of our favourite stretches of the series: linear rails, motors, lead screws, and the dual motor setup that comes with the V-Core 4.1 Hybrid upgrade.
Part 4: Finishing the Build
He wraps up the mechanical assembly and gets ready for first prints, and it shows: by this point he can barely wait to see the machine move.
Kit built, machine running, on to the real test.
When the printer became a lab
Most build series end with a benchy. KI Hestad's took a detour into materials testing instead. He needed reliable torque specs for M5 heat set inserts in PETG, for a structural part he was about to print: a 40×20 cm motorcycle seat tray that he "would prefer not to see turn into a kilogram of scrap."
The usual internet method, pulling on an insert with a luggage scale until it fails, doesn't tell you anything about rotational shear or how a joint holds up once it's actually torqued down. So he built his own test rig with a digital torque wrench instead. The first attempt broke in a way that invalidated the whole test.
The Threaded Insert Test YouTube Got Wrong
Rather than quietly fix it off camera, he published the failure, diagnosed the cause, and reran the test properly, this time getting consistent, trustworthy numbers for pilot hole size and torque limits.
The Threaded Insert Test I Got Wrong
The real test: on the road
With real data in hand, the seat tray went from CAD file to printed part to the frame of a Honda CB400N Super Dream, alongside a custom exhaust, rebuilt and rejetted carbs, and pod filters, as part of his cafe racer build.
It's exactly the kind of use case that tends to get lost in build logs and benchmark prints: a machine put to work on a part that actually has to survive being ridden.
Why we're sharing this
Open designs and standard hardware mean the V-Core isn't just a printer you finish building, it's a tool you keep building with. KI Hestad is a proper DIYer at heart, the kind of maker who'd rather build it himself than buy it ready made, and that's exactly who we design our kits for. If you want to follow along with his future builds, his channel is linked below.
Your rig, your rules.


